Download ##TOP## Insight Map Creator
Click Here >>>>> https://urloso.com/2tdg34
Sorry, arduino code is a bit confusing, you don't need the mega, as you said closer to arduino 1.0.0.0 and better. You need to connect your ps2 keyboard or other PC keyboard directly to the arduino then install new software, arduino ide, fsuipc IDE and run the fsuipc IDE, in this IDE, you set up the connection to motor, so you control your motor by typing numbers to set position in same way that you control the fsuIP by typing commands and numbers. I am sorry for asking so many questions at the same time, I just want to learn. Thank you for your patience.
Yes, I'm currently enabling the yoke and calibrating using the PFCFSX, but I didn't know of any other way to do so, but I could be missing something, but I'm not familiar with this type of tasking.
I am using the FSUIPC SDK to talk to the sim, and the PFC serial port to talk to the pfc (Pilot's Flight Computer). I have seen there are some libraries out there that can open pfcserial port, but have not been able to find a good pod to do so, and also do not know how to get data out of the pfc and write it to the pfcfsX serial port. So if you can post a sample of how to use this I would greatly appreciate it.
All you need to do is download FSUIPC from www.fsuipc.net and also download the arduino IDE and run the IDE. When you run the fsuipc IDE, you should connect the board to your computer via USB, then set up the serial port to the FSUIPC board. You then need to load the fsuipc serial software on your arduino and run FSUIPC from the arduino IDE. d2c66b5586