Scope Tactic ET20 Operating And Installation Instructions
CLICK HERE --->>> https://urllio.com/2tacUo
- Calibration of the boiler: the ET-500 can be calibrated in the field, through the programming mode (0, 1, 2) or by installing a program with a programmable controller (with a Micro Driver). - Calibration is based on the unit works only when the power supply is on (Thermostat on). - Calibration button (mode 0) on the back of the casing, located where thermostat (under the lid). - Calibration (mode 1) has 3 steps: the first is to program the temperature in the field (temperature, in ° C); the second is to enter the code (dude, thermostat); the third is to turn the power supply on (Thermostat on). - Calibration (mode 2) has 8 steps: the first is the same as in step 1 (first), the second is the same as the first, but with the thermostat off; the third is the same as the first, but with the thermostat off; the fourth is the same as the first, but with the thermostat off; the fifth is the same as the first, but with the thermostat off; the sixth is the same as the first, but with the thermostat off; the seventh is the same as the first, but with the thermostat off; the eighth is the same as the first, but with the thermostat off. - Calibration (mode 0) on the back of the casing, located where thermostat (under the lid). - Calibration (mode 1) has 3 steps: the first is to program the temperature in the field (temperature, in ° C); the second is to enter the code (dude, thermostat); the third is to turn the power supply on (Thermostat on). 827ec27edc